Rancang Bangun Prototype Penyangga Turbin Angin Archimedes

  • Eva Hertnacahyani Herraprastanti Teknik Mesin
  • Dimas Agung Gumelar Sekolah Tinggi Teknologi Ronggolawe Cepu
DOI: https://doi.org/10.51901/jme-sttr%20cepu.v2i2.203
Keywords: Prototype, Support, Archimedes Wind Turbine, 3D Printer

Abstract

In the Design and Build Prototype, the Archimedes Wind Turbine support is made using a 3D printer, as best as possible it is necessary to print and make a prototype for testing the strength of the material using Solidworks 2018 software. 2018. This Archimedes Wind Turbine Support supports the shaft, bearing, generator and turbine of 2.3016 Newtons. Based on the simulation results of the material strength test, it is known that the maximum Von-mises stress is 1.274 x 104, the deformation (displacement) is 2.877 x 103 and the strain is 4.953 x 106. The Safety Factor is 2354.8 so it can be said that Archimedes Wind Turbine Support strong and safe.

Published
2022-01-01
How to Cite
Herraprastanti, E., & Gumelar, D. (2022). Rancang Bangun Prototype Penyangga Turbin Angin Archimedes. JME (Jurnal Mekanika Dan Energi), 2(2), 25 - 31. https://doi.org/https://doi.org/10.51901/jme-sttr%20cepu.v2i2.203
Issue
Vol 2 No 2 (2021): JTME
Section
Articles
Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.